Brother TN730 WiFi Setup

If you are using printers, then you must know there is a requirement for the refilling of the cartridge. It is very important to choose the right cartridge for your printer, and it depends on the page yield being given by the particular cartridge. The yield being provided by the TN 730 cartridge is very good, and it is 1200 pages per cartridge. But, before you will use this cartridge, you must check the compatibility of your printer with the cartridge. In this article, you will not get the list of compatible printers, but also you will find out about the steps for the Brother TN730 Setup. 

List for Compatible Printers for Brother TN730

  • DCP-L2550DW
  • MFCL2750DW XL
  • MFCL2750DW
  • MFCL 2170DW
  • HL2370DW XL
  • HL2370DW
  • HL2395DW
  • HL2390DW

Therefore, you can use the Brother TN730 Cartridge in the printers listed above. So now, you will learn to connect Brother TN730 to WiFi in the next section of this article.

Steps to Install Brother TN730

The steps to install the Brother TN730 cartridge are very simple, and if properly done, you can complete the setup in a very easy way.

Step 1: In the very first step, in the front of the printer, open up the door of the cartridge.

Step 2: From the printer, remove the existing toner and drum unit. Don’t try to remove them individually. They will come as the one unit from the printer, as they cannot work alone without each other.

Step 3: Place the whole unit of drum/toner at the flat surface.

Step 4: As the drum used to work longer than the toner, like 12000 pages per drum, hence, there is just a need to replace the toner. In order to do that, try to find the green tab present on the left side of the drum. Pull down it, in order to remove it from the drum. Therefore, the toner will get detached from the drum.

Step 5: Now, open the new toner from the pack carefully. Make sure that the orange protective clip is removed from the cartridge before you will insert it or install it.

Step 6: Put back the drum/toner unit into the printer, and close the front cover of the printer. Now, you can start printing your documents.

Steps to do Brother TN730 WiFi Setup

Now, after the proper installation of the toner TN 730, you can start with the setup process. Follow the steps given below in order to complete the Brother TN730 Setup with the help of a wireless network.

Step 1: First, connect your system and printer with the help of a USB cable.

Step 2: Now, hold the button of the “ WiFi” indicator on your printer for 1-second. It will take 1-2 seconds to get ON the WiFi of your printer. The blue light will indicate that it has ON.

Step 3: Now, you need to change the infrastructure mode settings for the Printer. Now, open up the Printer Settings Tool, and follow the sequence by clicking Communication settings>General Tab>Selected Interface> Wireless LAN.

Step 4: Select the SSID of your network from the list of available networks.

Step 5: Fill up the password for your network, and click over Apply to change the settings.

Therefore, in this way, you will connect Brother TN730 to WiFi and can have the benefits of Brother TN730 toner. As this cartridge is compatible with many variants, hence there are fewer worries with the specificity. In case, still, you face any issue, you can contact our expert technicians. They will provide you with the best customer support services and will provide you with the best resolution in the market.